Welcome Anonymous
Fledgling
Fledgling
It is currently Sat Aug 18, 2018 12:04 am

All times are



Post new topic Reply to topic
Author Message
PostPosted: Wed May 02, 2018 12:56 pm 
Offline
Emperor
Emperor
User avatar

Joined: Wed Aug 04, 2010 2:37 pm
Posts: 767
Location: Decherd, Tennessee
This is the NEW CritterGetterPRO GENERATION 2 Camera Control Board. It runs on the Picaxe 18M2+SM microprocessor. The OpAmp running the PIR sensor is a MCP6044. It has 2 of the OptoCouplers so you can run two different cameras, a video/still picture camera, or a fast hacked camera as well. The board is perfectly square (52.8mm X 52.8mm). It is powered by 3AAA batteries. It has a programming header on the topside of the board so you don't have to remove it from the build to change the programming. It has 3 outputs to run anything you can dream up such as a mic preamp, or a exchanger. The board can be programmed to use the "Interrupt" method of triggering after a PIR Event is detected. It has a CDS Sensor for detecting day or night. It also has the Super Bright Blue LED for the Walk Test detection which can be seen even in direct sunlight. This board can be programmed by anyone using a Picaxe programming cable and the Picaxe Editor software. It comes with the standoffs and mount and screws. Sales for $48.00 and you can contact me at JTSWildlifeCameras@Gmail.Com


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic

All times are


Who is online


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group