Have a few questions.
1 Were is Q1 located on the board, its for the phototransistor for slave flash?
2 Can I just hard wire the wires to the board? the terminal blocks seem to always be out of stock.
3 Which components are needed to make a simple board to run a p32 with no slave.
AIO Board, Need some help
-
rick
- Posts: 513
- Joined: Fri Aug 13, 2010 8:35 pm
- Location: central kentucky
-
rick
- Posts: 513
- Joined: Fri Aug 13, 2010 8:35 pm
- Location: central kentucky
Re: AIO Board, Need some help
Well sure rick Ill try to help.
On #1 Q1 is not on the board, it goes in the terminal block marked E and C the long leg goes in the hole marked E.
# 2 you can but it would be aggravation to work on the board.
#3 If you have the parts go a head and put them in .You can always us the board on a different camera.
On #1 Q1 is not on the board, it goes in the terminal block marked E and C the long leg goes in the hole marked E.
# 2 you can but it would be aggravation to work on the board.
#3 If you have the parts go a head and put them in .You can always us the board on a different camera.
-
Darton man
- Posts: 224
- Joined: Sun Apr 10, 2011 7:22 am
Re: AIO Board, Need some help
Well thank you Rick ,I for one appreciate your wisdom
Since I am smack dab where you described,and cannot seem to get no where and.... am getting frustrated.
Since I am smack dab where you described,and cannot seem to get no where and.... am getting frustrated.
-
rick
- Posts: 513
- Joined: Fri Aug 13, 2010 8:35 pm
- Location: central kentucky
Re: AIO Board, Need some help
Darton man, don't get frustrated these boards are a lot of fun to work with. I have spent a lot of time looking through old post to find info on a lot of things about the AIO board. If you cant find what you are looking for just ask. there are a lot smarter guys on here than I.